Stargate
STARGATE (with or without sound)
How to Dial
WARNING: Pressing and holding the DHD button for more than 6 seconds will erase all settings!
To start the dialing sequence simply click the DHD button. After the dialing sequence competes, the gate will remain active for ~5 minutes and then close. If you purchased a Stargate with sound, then all the actions will have corresponding sound effects.
Pressing the DHD button again while the gate is in operation will start the sequence over
Important Note: The Stargate is more unique than the warp cores, as the lighting and sound are pre-programmed and timed with each other. Any changes to the lighting effects may result in a less than desired state of operation with the sound becoming out of sync.
WIFI Settings (advanced users only)
The below WIFI information will connect you to the gate if you feel advanced enough to play around with the settings:
WIFI SSID: Stargate
WIFI Password: HammondOfTexas
Note: If you connect the Stargate to your home WIFI it will automatically stop broadcasting it's own WIFI network. You will have connect to the gate using it's new IP address provided by your home WIFI router.
Stargate Tree Topper Mount
- Using a flathead screw driver, remove the bottom screw near the wires
- Slide the tree mount onto the Stargate and use the longer provided screw
- Insert the rod into the bottom of the mount, and secure the rod to the tree trunk using velcro straps or zip ties.
